2.10.3. Removal and installation of a poliklinovy belt

Removal

Fig. 2.44. Bolts of an exhaust pipe of an independent additional heater


In cars with an additional heater unscrew bolts of an exhaust pipe of an independent / additional heater from the noise-insulating screen (fig. 2.44).

Fig. 2.45. Fastening of a forward noise isolation


Weaken clips 1–3 and remove forward and back noise-insulating screens (fig. 2.45).

Fig. 2.474. Removal of a casing of the engine


Remove a casing of the engine (fig. 2.474).
Unscrew bolts.

Fig. 2.2. Air duct


Remove an air duct of 1 and 2 (fig. 2.2).
Remove a sealant of a motor compartment on a radiator frame.

Fig. 2.475. Fastening of the top part of the protection cover


Remove the top part of the protection cover, having released the fixing brackets (fig. 2.475).

NOTE
Before removal of a poliklinovy belt mark the direction of the course with chalk or a felt-tip pen. Change of the direction of the course of earlier operated belt can lead to its damage


Fig. 2.476. Weakening of a tension of a poliklinovy belt


For weakening of a tension of a poliklinovy belt turn a tension element in the direction of an arrow and record it by means of a mandrel (fig. 2.476).
Take off poliklinovy a belt.

Installation
Install components in the return sequence.

Fig. 2.477. Contour of a poliklinovy belt: 1 – quencher of tortional fluctuations; 2 – tension element; 3 – generator; 4 – pump of the hydraulic booster; 5 – bypass roller; 6 – conditioner compressor


Lay poliklinovy a belt on pulleys (fig. 2.477).
Holding a tension element a wrench, take a stopper and weaken a tension element.
Check correctness of laying of a poliklinovy belt.
Start the engine and check the belt course.