2.10.4. Removal and installation of a tension element of a poliklinovy belt

Removal
Bring a radiator frame into service situation.

Fig. 2.474. Removal of a casing of the engine


Remove a casing of the engine (fig. 2.474).

Fig. 2.478. Hose of an air duct of the electric motor of the gate of an inlet collector


Remove an air duct hose from the electric motor of the gate of an inlet collector, having slightly raised a fixing bracket (fig. 2.478).

Fig. 2.476. Weakening of a tension of a poliklinovy belt


For weakening of a tension of a poliklinovy belt turn a tension element in the direction of an arrow and record it by means of a mandrel (fig. 2.476).
Take off poliklinovy a belt.

Fig. 2.479. Removal of a tension element of a poliklinovy belt


Unscrew a bolt and remove a tension element of a poliklinovy belt (fig. 2.479).

Installation
Installation is carried out in the return sequence.
Before an inhaling check correctness of provision of a tension element on an arm of additional units.
Establish poliklinovy a belt.

Fig. 2.480. Lock bracket of an airwater hose


At installation of airwater hoses with shtekerny connections you watch that the lock bracket was latched for the holding ledge And with a characteristic sound (fig. 2.480).
Establish a radiator frame with hinged elements.
Lower an emphasis of a forward support at the expense of a body weight on the rubber buffer and tighten nuts.
Establish an overlay of a front bumper.

Inhaling moments
Tension element of a poliklinovy belt to the holder: 25 N · m.
Emphasis of a forward support to a radiator frame: 28 N · m.
Hose collars, width are 9 mm: 3 N · m.
Hose collars, width are 13 mm: 5,5 N · m.