2.10.5. Removal and installation of a quencher of tortional fluctuations

Removal
Bring a radiator frame into service situation.
Remove an engine casing.
Take off poliklinovy a belt.
Wring out a cover of a quencher of tortional fluctuations.

Fig. 2.481. Untwisting of a quencher of tortional fluctuations


Turn off a quencher of tortional fluctuations, holding the central bolt a cap wrench (fig. 2.481).

Installation
Installation is made in the return sequence.
Establish a quencher of tortional fluctuations with new original bolts.

Fig. 2.482. Adjusting provision of a quencher of tortional fluctuations


Installation is possible only in one situation: the opening of a quencher of tortional fluctuations has to be over a ledge of a gear wheel of a gear belt (fig. 2.482).
Establish poliklinovy a belt.
Establish a radiator frame with hinged elements.
Lower an emphasis of a forward support at the expense of a body weight on the rubber buffer and tighten nuts.
Establish an overlay of a front bumper.

Inhaling moments
Quencher of tortional fluctuations to коленвалу*: 10 N · m +90 ° **.
Emphasis of a forward support to a radiator frame: 28 N · m.
Hose collars, width are 9 mm: 3 N · m.
Hose collars, width are 13 mm: 5,5 N · m.
* Replace bolts.
** 90 ° correspond to one quarter of a whole revolution.