2.3.25. Replacement of manzhetny consolidation of a final cam-shaft

Fig. 2.54. Engine casing


Remove a casing of the engine (fig. 2.54).

ATTENTION
When opening the broad tank can come out hot steam or hot cooling liquid. Wrap up a cover rags and carefully open a tank.

Open a cover of a broad tank of the cooling system.

Fig. 2.44. Bolts of an exhaust pipe of an independent additional heater


In cars with an additional heater unscrew bolts of an exhaust pipe of an independent additional heater from the noise-insulating screen (fig. 2.44).

Fig. 2.45. Fastening of a forward noise isolation


Weaken quick disconnect couplings 1 and 2 and remove a forward noise isolation (fig. 2.45).
Merge cooling liquid.
Take off a gear belt.

Fig. 2.164. Untwisting of a gear wheel of a cam-shaft


Weaken a cam-shaft gear wheel (use a countersupport) (fig. 2.164).

Fig. 2.147. Removal of a belt pulley of a cam-shaft two-gripping stripper


Remove a cam-shaft gear wheel by means of a stripper and captures (fig. 2.147).

Fig. 2.178. Installation of a stripper of epiploons


For installation of a stripper of epiploons twist the special tool of a stripper of epiploons in a cam-shaft against the stop by hand (fig. 2.178).
Unscrew an internal part of a stripper of manzhetny consolidation on two turns (a comment of 3 mm) from an external part and record the screw with a knurled head.

Fig. 2.179. Screwing of a carving head


Grease a carving head of a stripper of manzhetny consolidations with engine oil, establish and, having strongly pressed, twist it as it is possible more deeply in manzhetny consolidation (fig. 2.179).
Weaken the screw with a nakatny head and to turn an internal part against a cam-shaft until manzhetny consolidation is removed.
Clamp a stripper of manzhetny consolidations on flat edges in a vice. Remove manzhetny consolidation with a grip.

Installation
Do not grease a working edge of an epiploon.

Fig. 2.180. Installation of the directing plug


Put on the directing plug of the adjusting device a neck of the camshaft (fig. 2.180).
Put on an epiploon via the directing plug a cam-shaft neck.
Remove the directing plug.

Fig. 2.181. An epiploon press fitting by means of the directing plug and a bolt of the adjusting device


Press an epiploon by means of the directing plug and a bolt of the adjusting device against the stop (fig. 2.181).
Establish a cam-shaft gear wheel.

Adjusting situation

Fig. 2.182. Adjusting provision of a gear wheel of a cam-shaft


The edge of a gear wheel of a cam-shaft has to be directed outside and the tag of BMT 1 is seen (fig. 2.182).
Tighten a bolt of fastening of a gear wheel of a cam-shaft (use a counterkey) (fig. 2.164).

NOTE
When scrolling a cam-shaft valves can collide the pistons which are in the top dead point. Therefore pistons should not be in VMT. There is a danger of damage of valves/piston.

Establish a gear belt.
Establish a radiator frame with hinged components.

Fig. 2.96. Fastening of the rubber buffer


Lower a support emphasis against a provorachivaniye at the expense of a body weight on the rubber buffer and tighten nuts (fig. 2.96).
Establish a casing of a front bumper.
Check adjustment of headlights.
Inhaling moment:
– an asterisk to a cam-shaft – 50 N · m +180 °;
– an emphasis of the shaking support – 28 N · m