2.3.6. Replacement of manzhetny consolidation of the crankshaft on the party of a belt pulley

Removal
Take off poliklinovy a belt.
Remove gear ремнь.

Fig. 2.110. Keeping of a pulley of the crankshaft countersupport


Establish a belt pulley of the crankshaft (for a gear belt), holding a pulley a countersupport (fig. 2.110).

Fig. 2.111. Removal of a pulley of the crankshaft


Turn off the central bolt of 1 belt pulley of the crankshaft (for a gear belt) and remove a pulley 2 and a diamond washer of 3 (fig. 2.111).

Fig. 2.112. Installation of the central bolt in the crankshaft


For input of a stripper of manzhetny consolidations twist the central bolt in the crankshaft against the stop manually (fig. 2.112).
Unscrew an internal part of a stripper of epiploons on nine turns (about 20 mm) from an external part and record the screw with a nakatny head.

Fig. 2.113. Screwing of a carving head in manzhetny consolidation


Grease a carving head of a stripper of manzhetny consolidations with engine oil, establish and, having strongly pressed, twist it as it is possible more deeply in manzhetny consolidation (fig. 2.113).
Weaken a bolt with a nakatka and to turn an internal part of a stripper against the crankshaft until the epiploon is extended.
Clamp a stripper of manzhetny consolidations on flat edges in a vice. Remove manzhetny consolidation with a grip.

Installation
Clear working and sealing surfaces.
Remove the oil remains on a conrod neck of a bent shaft by means of pure rags.

Fig. 2.114. Installation of the directing plug


Get the directing plug of adjusting adaptation on a neck of the crankshaft (fig. 2.114).
Establish a sealing ring via the directing plug on a neck of a bent shaft.

Fig. 2.115. An epiploon press fitting by means of the central bolt of fastening of a pulley and the press plug of adjusting adaptation


Press an epiploon by means of the central bolt of fastening of a pulley and the press plug of adjusting adaptation aflush (fig. 2.115).
Replace the central bolt for a belt pulley (for a gear belt).

NOTE
On adjacent surfaces between a driving asterisk of a gear belt and the crankshaft there should not be an oil.
In addition do not grease a crankshaft gear wheel bolt.

Establish a crankshaft 2 pulley (for a gear belt) with a new diamond washer 3 and a new central bolt of 1 (fig. 2.111).
Record a pulley a countersupport and fix (fig. 2.110).

Installation of a gear belt (adjustment of phases of gas distribution)
Establish poliklinovy a belt.
Establish a radiator frame with hinged components.

Fig. 2.96. Fastening of the rubber buffer


Lower a support emphasis against a provorachivaniye at the expense of a body weight on the rubber buffer and tighten nuts (fig. 2.96).
Establish a casing of a front bumper.
Check adjustment of headlights.

Inhaling moment
Emphasis of the shaking support: 28 N · m.
Asterisk of the drive of a gear belt to коленвалу*: 90 N · m +90 ° **.
* Replace a bolt.
** 90 ° there correspond quarters of a turn.