2.3.8. Removal and installation of a two-mass flywheel

Removal
The engine or the check point are removed.
Remove press a clutch plate.

ATTENTION
Not to allow damage of a two-mass flywheel at removal, bolts In cannot be unscrewed a pneumatic vintovert. It is allowed to unscrew bolts only by hand.


Fig. 2.121. Provorachivany two-mass flywheel


Turn a two-mass flywheel And so that bolts In rose on the center of openings (fig. 2.121).
When untwisting bolts In track that heads of bolts did not rest against a two-mass flywheel and at a provorachivaniye did not damage it.

Fig. 2.122. Installation of countersupport


Insert a countersupport into an opening on the block of cylinders B (fig. 2.122).
Mark the provision of a two-mass flywheel concerning the engine.
Turn off a flywheel.

Installation
Installation is carried out in the return sequence.
For fastening use new bolts.
Insert a countersupport into an opening on the block of cylinders A (fig. 2.122).
The inhaling moment a two-mass flywheel to the crankshaft. Length болтов*:
– 22,5 mm – 60 +90 ° **
– 35,0 mm – 60 +180 ° ***
– 43,0 mm – 60 +180 ° ***
* Replace a bolt.
** 90 ° there correspond 1/4 turns.
*** 180 ° there correspond 1/2 turns.