2.6.17. Pumping of fuel from a tank

Operating procedure

Fig. 2.256. Removal of a cover of the accumulator


Take away an accumulator cover 1 to the right and remove it, lifting 2 (fig. 2.256) up.
Disconnect a weight wire from joint stock bank at the switched-off ignition.

ATTENTION
Attach a wire of mass of the device for pumping of fuel to the pure unpainted place of a body.


Fig. 2.257. Removal of a conic nozzle from the device handle for fuel pumping


Remove a conic nozzle 2 from the device handle 1 for pumping of fuel (fig. 2.257).
Paste on a hose for pumping an insulating tape piece at mm A=1465 distance from its end.
Turn off a cover of a jellied mouth of the fuel tank.

Fig. 2.258. Installation of the handle of the device for pumping of fuel to a jellied mouth of the fuel tank


Fasten the handle of 1 device for pumping of fuel to a jellied mouth of the fuel tank (fig. 2.258).
Lower the pumping-out hose in the fuel tank so that earlier made tag was at the handle.

NOTE
When using of the pumping-out device without handle work is performed similarly.


Fig. 2.259. The scheme of pumping of fuel from a tank


In this case paste a tag to the pumping-out hose at mm A=1400 distance from its end (fig. 2.259).
The hose for pumping of fuel is inserted correctly if the pasted tag is at the level of an edge of a jellied mouth.
If the hose passes hardly, slightly oil it engine. Do not use for this purpose silikonsoderzhashchy lubricant at all
Pump out fuel from a tank through a jellied mouth.
Carefully pull out a hose.