2.8.2. Removal and installation of a poliklinovy belt

Fig. 2.301. Components of a contour of a poliklinovy belt: 1 – poliklinovy belt; 2 – bolt of 30 N · m; 3 – bolt of 22 N · m; 4 – generator; 5 – a casing of the directing roller; 6 – the directing roller of a poliklinovy belt; 7 – bolt of 20 N · m; 8 – a pulley of the belt drive for the water pump; 9 – bolt of 9 N · m; 10 – water pump; 11 – casing of a natyazhitel; 12 – natyazhitel of a poliklinovy belt; 13 – bolt of 20 N · m; 14 – bolt of 20 N · m; 15 – power steering pump arm; 16 – bolt of 20 N · m; 17 – power steering pump; 18 – bolt of 20 N · m; 19 – pulley of the belt drive of the pump of the power steering; 20 – bolt of 20 N · m; 21 – bolt of 25 N · m; 22 – conditioner compressor; 23 – adjusting plug; 24 – conditioner compressor arm; 25 – damper of tortional fluctuations



Removal

Fig. 2.302. Forward facing of the engine


Remove forward facing of the engine (fig. 2.302).
Unscrew bolts.

Fig. 2.2. Air duct


Remove air ducts of 1 and 2 (fig. 2.2).

Fig. 2.44. Bolts of an exhaust pipe of an independent additional heater


On cars with an autonomous heater unscrew bolts of an exhaust pipe of an autonomous / additional heater on the noise-insulating screen (fig. 2.44).

Fig. 2.45. Fastening of a forward noise isolation


Turn off clamps 1 and 2 and remove the forward noise-insulating screen (fig. 2.45). The back noise-insulating screen remains established.
Remove facing of a front bumper.
Bring a radiator frame into service situation.

NOTE
Before removal of a poliklinovy belt mark the direction of the course with chalk or a felt-tip pen. Change of the direction of the course of earlier operated belt can lead to its damage.


Fig. 2.303. Weakening of a tension of a poliklinovy belt


For weakening of a poliklinovy belt move a natyazhitel in the direction of an arrow (fig. 2.303).
Take off poliklinovy a belt and unload a natyazhitel.

Installation
Installation is carried out in the return sequence,

Fig. 2.304. Contour of a poliklinovy belt: 1 – generator; 2 – the directing roller; 3 – water pump; 4 – power steering pump; 5 – conditioner compressor; 6 – natyazhitel of a poliklinovy belt; 7 – bent shaft


Establish poliklinovy a belt on pulleys as it is shown in the figure 2.304.

NOTE
At installation of a poliklinovy belt you monitor the correct provision on pulleys.

Establish a radiator frame with hinged details.
Start the engine and check the belt course.
Establish facing of a front bumper.