2.9.6. Removal and a press fitting of the needle bearing in a flywheel

Fig. 2.401. Components of a two-mass flywheel: 1 – two-mass flywheel; 2 – needle bearing; 3 – special bolt; 4 – bent shaft; 5 – a crankshaft epiploon from the chain drive



Remove press a clutch plate.

Fig. 2.314. Extraction of the needle bearing


Take the needle bearing by means of an internal stripper and a countersupport (fig. 2.314).

Fig. 2.315. Press fitting of the needle bearing


Press the needle bearing in a two-mass flywheel by means of a mandrel against the stop (fig. 2.315).
Establish press a clutch plate.