Establish a new protective cover of the hinge on a power shaft.

Fig. 3.131. Napressovka of a lock ring

Napressuyte a lock ring 1 to the middle of teeths (fig. 3.131).

Fig. 3.132. Installation of the assembly tool

Use the special tools presented in the figure 3.132.

Instead of assembly T10065/2 adaptation it is necessary to use, depending on execution of a power shaft, T10065/3.

Napressuyte an asterisk on a power shaft

The facet on an asterisk is turned to a power shaft, it serves for convenience of assembly.

Before montazhy hinge or asterisk of the tripoidny hinge teeths And

Fig. 3.111. A facet on an asterisk of the Tripod hinge

it is necessary to cover with a thin layer of the lubricant used for the hinge (fig. 3.111).

Establish an asterisk of the tripoidny hinge on a shaft according to a mark and spread against the stop.

Fig. 3.133. Installation of an asterisk of the tripoidny hinge on a shaft

The submitted figure 3.133 concerns only privodny the shaft having a cone on the end.

Use the special tools presented in the drawing.

The special T10065/2 tool cannot be rested against a swing body

Fig. 3.134. Installation of an asterisk of the tripoidny hinge on a shaft

The submitted figure 3.134 concerns only power shafts having the cylindrical end.

Use the special tools presented in the drawing.

Napressuyte an asterisk of the tripoidny hinge on a power shaft

The key ring has to be recorded with the heard click, the asterisk has to adjoin to a key ring without gap.

Fig. 3.135. Installation of a lock ring: 1 – pincers (usual)

Enter from the back party of the Tripod hinge 70 g of lubricant for power shafts from a repair kit.

Slightly grease a swing body

You watch that bodies of swing did not warp.

By means of the plastic hammer get a hinge element on an asterisk of the tripoidny hinge.

Fig. 3.136. Installation of an element of the hinge on an asterisk of the tripoidny hinge

In the figure 3.136 the assembly tool for a power shaft of AAR 3300i is shown.

Drive the remained lubricant into a hinge boot.

You monitor the correct provision of a boot on a hinge element.

The protective cover has to be established in a flute on hinge case perimeter

Fig. 3.137. The provision of an element of the hinge at installation

Establish a hinge element on average situation. See min./max. situation (fig. 3.137).

NOTE At installation of a holder of the hinge in average situation let out the air from a hinge cover, for example, by means of the screw-driver.

Establish a collar.

Fig. 3.138. Adjusting provision of a collar

NOTE That it was easier to install screws with an internal gear wreath in a head at installation of a power shaft, it is necessary that the eye 2 collars was between ledges (at a cut) a flange of 1 holder of the hinge (fig. 3.138).

Fig. 3.139. Fixing of a small collar

Fix a small collar by means of pincers (fig. 3.139).