4.3.5. Removal of a screw spring

Fig. 4.61. Compression of a spring coupler


Clamp a depreciation rack in a vice (fig. 4.61).
Squeeze a screw spring by means of a coupler of a spring and capture so that the top cup of a spring was released.

Fig. 4.62. Correct landing of a spring


Provide appropriate landing of a twisted spring in captures (fig. 4.62).
Turn off a nut with a flange from a rod by means of special tools.
Remove separate details of a depreciation rack and the compressed spring by means of a coupler of a spring (fig. 4.61).
Replace the shock-absorber.

Fig. 4.63. The correct provision of the lower plate of a spring in relation to the shock-absorber


Remove a protective cap 1 and the lower support of a spring of 2 (fig. 4.63).
Note the provision of the lower plate of a spring in relation to the shock-absorber.
Weaken a plate of a spring 3 by means of the plastic hammer and remove in the direction up.

Assembly provision of the lower plate of a spring

Fig. 4.64. Assembly provision of the lower plate of a spring



A – A shock-absorber screw axis / the bearing lever.
I = at the left, B = 65 ° ±2 °.
II = on the right, C = 87 ° ±2 °.
Blows of the plastic hammer push a plate of a spring on the drawn mark down.
At installation of a new damper transfer a mark from an old damper.
You monitor various provision from the left and right side.
The cut in a plate of a spring has to provide a free wheeling to a body.