4.4. Back suspension bracket

Removal and installation of a twisted spring
Removal and installation of the shock-absorber

Fig. 4.102. Stretcher of a back suspension bracket (forward drive): 1 – stretcher; 2 – plastic insert; 3 – washer; 4 – the combined screw; 5 – washer

Fig. 4.103. Stretcher of a back suspension bracket (four-wheel drive): 1 – stretcher; 2 – the combined screw, 55 N · m; 3 – washer; 4 – six-sided nut; 5 – plastic insert; 6 – washer; 7 – the combined screw; 8 – washer; 9 – KP forward support; 10 – the combined screw, 40 N · m; 11 – guard; 12 – the combined screw, 25 N · m; 13 – reverse main gear; 14 – cross beam back; 15 – the combined screw, 40 N · m; 16 – six-sided nut, 40 N · m; 17 – washer; 18 – the combined screw

Fig. 4.104. Stabilizer of a back suspension bracket: 1 – stabilizer; 2 – collar; 3 – the screw with a fillet, 25 N · m; 4 – support; 5 – stabilizer rack; 6 – the screw with a fillet, 25 N · m; 7 – the screw with a fillet, 45 N · m

General provisions
At installation of details with an anticorrosive covering it is necessary to clean the surfaces of interface. On the surfaces of interface there should not be traces of an anticorrosive covering and fat.
The moments of an inhaling are given for ungreased bolts and nuts.
Carrying out welding or leveling works with the bearing or directing elements of a suspension bracket is inadmissible.
Avoid the following impacts on screw springs: blows by the hammer, hit of drops of metal when welding, the subsequent drawing color designations.
In the area vintovy springs and depreciation racks you do not carry out any welding and grinding (is sharp) works. If necessary close a screw spring / depreciation racks.
It is forbidden to move cars without the established power shafts since in this case the wheel bearing is damaged. If, nevertheless, the car it is necessary to move, observe the following operations procedure.
Install the external hinge instead of a power shaft.
Tighten the external hinge with the moment of 115 N · m (M14 screw) or 200 N · m (M16 screw).
Rubber-metal hinges (saylent-blocks) have the limited working range of twisting. Therefore tighten threaded connections of levers only on the empty car
If still check of angles of installation of wheels is necessary to the car, then to tighten the screws and nuts unscrewed at installation of corners, it is necessary only with the required moment. After performance of work on exposure of angles of installation of wheels hold on screws and nuts on the required dovorachivaniye corner.