6.3.11. Removal and installation of a basic pillow for a brake pedal

ATTENTION
Should not interfere with the course of a pedal of a brake additional floor mats.

Fig. 6.63. Brake pedal components: 1 – cross beam of the forward panel; 2 – safety lock (2 pieces); 3 – fingers; 4 – basic pillow; 5 – the screw with an internal hexagon, 10 N · m; 6 – accelerator pedal module; 7 – the combined screw, 25 N · m; 8 – switch of lamps of a stoplight; 9 – coupling switch; 10 – cylindrical screw, moment of an inhaling of 5 N · m; 11 – the combined screw, 20 N · m; 12 – brake pedal; 13 – main cylinder of the drive of coupling; 14 – press spring; 15 – preservation; 16 – coupling pedal; 17 – connecting pin



Removal
Remove a ware compartment from the driver.

Fig. 6.64. Twisting of protection against twisting and removal of the plug


Unscrew protection against twisting (the cylindrical screw) 3 on a basic pillow (fig. 6.64).
Squeeze the plug 2 in the direction of an arrow and disconnect the switch of a stoplight (fig. 6.64).

Fig. 6.14. Turning of the switch of stoplights


1 turn the switch of a stoplight on 45 ° to the left and take (fig. 6.14).

Fig. 6.15. Connection of a pedal of a brake and amplifier of the brake drive


Disconnect a pedal of a brake from the amplifier of the brake drive by means of a stripper (fig. 6.15).

Fig. 6.65. Lock clip of a pedal of a brake


Disconnect a lock clip 1 on the right side (fig. 6.65).
Take a pin so that release a brake pedal.
Take a brake pedal.

Installation
Enter a pin through a brake pedal.
Delay protection against twisting (the cylindrical screw) only when lock clip-on earrings are put on.
Establish protection against twisting (the cylindrical screw) 3 on a basic pillow (fig. 6.64).
Mount the stoplight switch.
Further assembly is carried out in the return sequence.