6.3.4. Ceramic brake of forward wheels of CSIC

Fig. 6.38. Ceramic brake of forward wheels of CSIC: 1 – screws for a brake support; 2 – the holding spring for brake shoes; 3 – the directing bolt; 4 – case of a brake support; 5 – brake shoes; 6 – the fixing bolt; 7 – brake disk; 8 – guard; 9 – screws for a guard; 10 – bolt; 11 – bracket holder; 12 – piston of the brake cylinder; 13 – holder's screw; 14 – connection of the brake pipeline to a brake hose; 15 – pipeline of the brake system; 16 – arm of the brake highway; 17 – connection of the brake pipeline to a brake support; 18 – the screw of the directing finger



NOTE
Always to establish full ремкомплект.

After replacement of brake shoes several times strongly press a brake pedal in a motionless state brake shoes reached the position corresponding to their working condition.
For pumping of brake fluid from a broad tank use capacity for pumping out which adjoins only to brake fluid. Brake fluid is toxic agent therefore it cannot be pumped out a mouth through a hose at all.

ATTENTION
Pistons of the brake cylinder have various diameter. At installation into place you watch that each piston was inserted into the opening corresponding to it in a brake support. Ceramic plugs on the piston of the brake cylinder serve as a heat insulator and should not separate from the piston. At damage of the ceramic plug it is necessary to replace the piston of the brake cylinder for reasons of safety.