7.5.5. Removal and installation of the 9-nested block of the relay

Removal
Switch off ignition and pull out the ignition key.
Remove a ware compartment from the driver.
Turn off nuts 3 and remove the control unit of onboard network. with the connected cables.

Fig. 7.93. Fastening of the 9-nested block of the relay


Remove the 9-nested block of the relay 4 (fig. 7.93).

NOTE
1 and 2 do not take into account.

Disconnect blocks of safety locks from the 9-nested block of the relay.

Fig. 7.94. 9-nested block of the relay


Take the relay, control units, and then unblock the corresponding payment of the relay (fig. 7.94).

Installation
Establish in the return sequence.
Establish a ware compartment from the driver.

Inhaling moment
The 9-nested block of the relay with the control unit of onboard network to the central pipe of the forward panel: 2,4 N · m.