7.5.6. Removal and installation of the 3-nested block of the relay

Removal
Switch off ignition and pull out the ignition key.
Remove a ware compartment from the driver.

Fig. 7.95. Fastening 3-nested block of the relay


Unscrew screws 1 and remove the 3-nested block of the relay 2 (fig. 7.95).

NOTE
Poses. 3 and 4 do not take into account.


Fig. 7.96. 3-nested block of the relay


Disconnect blocks of safety locks from the 3-nested block of the relay (fig. 7.96).
Take the relay, control units, and then unblock the corresponding payment of the relay.

Installation
Establish in the return sequence.
Establish a ware compartment from the driver.

Inhaling moment
The 3-nested block of the relay to the central pipe of the forward panel: 3 N · m.