8.2.3. Adjustment of a forward door

NOTE
For exact adjustment of a door on height, an inclination and shift use the special tool (fig. 8.59).

NOTE
The back door has to be adjusted.

Width of a joint can be checked the special tool 3371.
Size A = 3,5 mm ±0,5 mm.
Size B = 4,5 mm ±0,5 mm.

Adjustment in the longitudinal direction
Adjustment in the longitudinal direction is carried out by weakening of bolts And on a rack And the top and/or lower hinge of a door and movement of a door 2 (thanks to the increased openings in the hinge and a rack And) (fig. 8.60).

Fig. 8.60. The scheme of adjustment of a forward door in the longitudinal direction


Moment of an inhaling of 32 N · m

NOTE
In the figure 8.60 the lower hinge of a door is shown.

Adjustment concerning the center of the car

Fig. 8.61. The scheme of adjustment of a forward door in relatively center of the car


Adjustment concerning the center of the car is carried out by weakening of bolts of the hinge B above and/or below and movements of a door (grooves in the hinge) (fig. 8.61).
Moment of an inhaling of 32 N · m

NOTE
On the top and lower hinges of a door it is established on an adjusting bolt with a fillet.
Therefore, as a rule, when performing repair adjustment is not required.
If nevertheless adjustment is necessary, adjusting bolts with a fillet can be replaced with the bolts of the same size, length and durability offered in the catalog of spare parts.

NOTE
In a back part of a door adjustment is carried out by means of a lock bracket (in the direction to the center of the car).

Adjustment by means of a lock bracket
Weaken bolts 2.
And or arrows C use tags for side adjustment (fig. 8.62).

Fig. 8.62. The scheme of adjustment by means of a lock bracket


Shift a lock 1 bracket so that the door was established aflush with a contour of a body (fig. 8.62).

NOTE
Adjustment is allowed only in the direction to the center of the car, but not on height.
Use tags of an arrow B or an arrow D for adjustment on height.
At the correct adjustment the bracket of the lock has to enter the door lock on the center.

Tighten screws the moment of 25 N · m.