After the end of preparatory work it is necessary to apply glue.

Fig. 8.99. Putting glue

Establish a nozzle by all surface 2 on glass (fig. 8.99).

The direction of drawing – the shooter (fig. 8.99).

NOTE Section of the glue roller 1 is defined by an opening of a nozzle and speed of drawing.

Fig. 8.100. Putting glue on perimeter

Apply glue-sealant on perimeter according to the figure 8.100.

Consider various distance to the edge of glass

Insert glass into an aperture by means of two double vacuum captures.

ATTENTION Glass needs to be inserted within 15 min. after putting glue as differently its gluing properties will decrease.

Level glass in the cross direction.

The distance from the edge of glass to a frame of a roof has to make 6 mm +0,5 mm.

Fig. 8.101. Installation of a water protective slip

1 insert a water protective slip and press against the stop in fixing brackets 2 only after time of hardening of glue (fig. 8.101).

By pressing you watch that the sealing edge (arrow) of a water protective slip adjoined to glass and did not slide off for the edge of glass.

Fig. 8.102. Installation of a sticker

You apply a sticker (e.g. safety cushions) on a new windshield on the former place (fig. 8.102).

Size a = 25 mm.

Size b = 10 mm.